Side Indicators - Clear
indicators must first be purchased. I used a credit card to removal the
old yellow ones. Slide the card under the front side of the indicator to
push in the single tap that holds it in, pull out to remove. There are two
wires attached to the back, move these to the clear indicator now so not
to confuse the terminals. Then snap the new indictor back into place.
Turn Signal Assembly - Remove the assembly from
the car and twist off the plastic bulb holders. Cover the end of a long
flat head screwdriver with tape to prevent scratching the lens. Use the
screwdriver to pry the reflector off the inside of the assembly, it is
held on my a small amount of glue at the edges. The hole is too small to
remove the reflector so it must first be broken into smaller pieces, wire
cutters or pliers work well. When all pieces are removed, reinstall signal
assembly.
Cost: $15 for side indicators, free for Turn Signal
Assembly
Time: 45 min for Turn Signal Assemblies, 5 min for Side
Indicators
Difficulty: Easy |
 |
