|
Rear Anti-Sway Bar |
|
| Pictured at the right is my old bar, it
was rusted and bent out of shape after 72k miles, and It was also
incredibly small at only 1/2" diameter. The SAS Anti-Sway Bar is 7/8" in
diameter and will not rust away. It is highlighted in the bottom picture
and is pale gold in color. Installation - The anti-sway bar is held in place by two bolts on either side. For easier access raise the back of the car. Using the correct size socket remove the four bolts. Take off the old anti-sway bar and insert the new one. The holes on the new bar are larger than needed, which gives the bar some play. Slide the bar as far back as possible and reapply the four bolts and toque to 40 ft-lbs. Make sure that the bolts cover the hole entirely, if they are not big enough you need to purchase larger ones. Cost: $125 Time: 45 min Difficulty: Moderately-Easy  |
 
|
| Home |